1.The machine is mainly composed of feeding port, aligning drum, traction feeding mechanism, hydraulic cutting mechanism frame, material bearing frame, motor driving mechanism and electrical control box.

2.The rod rack is installed 4 M away from the main engine to store the rebar of the coil.

3.The aligning drum is driven by a motor through a triangular belt. There are five aligning molds in the aligning drum to adjust the curve amplitude to a certain extent according to different line diameters (the wire with too small amplitude is crescent bend, and the wire with too large amplitude is wave line).

4.Traction feeding device by the servo motor through the synchronous belt transmission to the reducer gear, then synchronization to the traction wheel, to choose the appropriate slot according to different wire diameter, the traction wheel clamping wire feed forward, and can realize speed regulation and the gauge length, reaches the set length after stop drive, hydraulic cutting start again after the second root feeding.